Pet supply organizer.

I haven't posted a project in awhile, so I wanted to share my latest. It's a toy bin that I did for my pooches. What I enjoy about this toy bin is how delicately they select their toys out of it, like they know I made it for them and how mad I'd be if they messed it up. I've trained them well, maybe?

Supplies and Tools:

FolkArt® Acrylic Paint
Coffee Bean
Sky Blue
Terra Cotta
Mod Podge® - Gloss
Wood bin - mine is from JoAnns from their everyday wood section
Wood balls for feet (1.5") - 4
Scrapbook paper - I used KI Memories Pet Shop purchased at JoAnns, 2 sheets
Embellishments - Spare Parts brand from Hobby Lobby, bones and paws
Ribbon - I used KI Memories Pet Shop, 2 rolls of striped purchased at JoAnns
Buttons - brown, a total of 8 (4 for each side)
Flat Paint Brush
Beacon's Premium Tacky Glue
Stencil tape
Scissors
Ruler
Pencil or pen

1. I always trace the shapes for my finished project first. Why? Because if pencil marks get on my surface, then I can paint over them. Start by tracing the side of your bin onto the back of both sheets of paper. Using the ruler, measure 1/2" on the inside of the tracing lines. Use the scissors to cut out the sheets and then set aside.
2. Use the paint to basecoat the inside of the bin Coffee Bean and the entire outside and bottom Sky Blue. Allow to dry. Paint the four wood balls with Coffee Bean and allow to dry.
3. When the paint is dry, use the stencil tape to make stripes on the sides with the handles. Paint a few coats of Terra Cotta on the exposed areas, and remove the stencil tape as soon as you are done. Allow to dry.
4. Use the Mod Podge to apply the two paper shapes to the sides without the handles. Completely smooth out all air bubbles and allow to dry for 15 – 20 minutes.
5. Coat the entire bin with at least two coats of Mod Podge. Do the wood balls at this time as well. Allow to dry completely.
6. Cut the ribbon to trim around the edges of the paper and glue down. Glue the bone and paw embellishments down on the striped side. Glue the buttons down where the ribbon meets. Finally, glue the wood balls to the bottom of the bin as feet.
7. Allow the bin to dry for at least 24 hours before using.